Blar i Institutt for bygg- og miljøteknikk på tittel
Viser treff 2173-2192 av 4774
-
Influence of grain size, organic carbon and organic matter residue content on the sorption of per- and polyfluoroalkyl substances in aqueous film forming foam contaminated soils - Implications for remediation using soil washing
(Peer reviewed; Journal article, 2023)A soil that was historically contaminated with Aqueous Film Forming Foam (AFFF) was dry sieved into size fractions representative of those produced during soil washing. Batch sorption tests were then conducted to investigate ... -
Influence of Gravel-Bed Porosity and Grain Orientation on Bulk Flow Resistance
(Journal article; Peer reviewed, 2018)This paper presents results from experiments that were carried out to study the effect of porosity and grain orientation on flow resistance. Experiments were performed over three rough surfaces; a water-worked gravel-bed, ... -
The Influence of Icephobic Nanomaterial Coatings on Solar Cell Panels at High Latitudes
(Peer reviewed; Journal article, 2022)Solar energy’s penetration at high latitudes has been boosted during recent years, but snow deposits during the winter still limit its exploitation. Therefore, various solutions for snow removal, such as icephobic coatings, ... -
Influence of large-scale asperities on the shear strength of concrete-rock interface of small buttress dams
(Peer reviewed; Journal article, 2021)This paper presents an investigation of the influence of large-scale asperities on the shear strength of four physical models of a pillar (also known as buttress web)from Kalhovd dam in Norway. The objective was to observe ... -
Influence of large-scale asperities on the stability of concrete dams
(Chapter, 2022)For concrete dams founded on rock, there are only a few options in the common analysis methods to account for large‐scale asperities. However, previous research alludes that they have a significant impact on the behaviour ... -
Influence of Local Weather Conditions on Ventilation of a Pitched Wooden Roof
(Journal article; Peer reviewed, 2020)This paper investigates the influence of temperature and wind conditions on ventilation of the air cavity beneath the roofing in a full-scale pitched wooden roof construction. The potential for condensation in the air ... -
Influence of location of large-scale asperity on shear strength of concrete-rock interface under eccentric load
(Peer reviewed; Journal article, 2020)The location and geometry of large-scale asperity present at the foundation of concrete gravity dams and buttress dams affect the shear resistance of the concrete-rock interface. However, the parameters describing the ... -
Influence of marine growth on support structure design for offshore wind turbines
(Master thesis, 2012)This Master's thesis addresses the effects of marine growth on the design of a lattice tower substructure for an offshore wind turbine. Marine growth is the unwanted colonization of marine structures by marine organisms. ... -
Influence of material factors on the determination of dynamic moduli and associated prediction models for different types of asphalt mixtures
(Peer reviewed; Journal article, 2022)In a Mechanistic-Empirical (ME) pavement design system, the dynamic modulus is used to characterise asphalt mixtures, which are affected by many factors including environmental conditions and material properties. This study ... -
Influence of NaCl Aqueous Solution on Compacted Snow: Field Investigation
(Peer reviewed; Journal article, 2020)Slippery road surfaces are a threat to traffic safety, especially in winter when snow falling on roads forms a hard crust that is extremely difficult to remove. To prevent this hard crust formation, salt is applied to ... -
Influence of Physical Properties of Marine Clays on Electric Resistivity and Basic Geotechnical Parameters
(Master thesis, 2013)Adding resistivity measurements to classical cone penetration tests (CPTU) provides further information useful for stratigraphy interpretation. Resistivity CPTUs (R-CPTU) have already been used for quick clay mapping, but ... -
Influence of Shell Materials on the Optical Performance of VO2 Core-Shell Nanoparticle-Based Thermochromic Films
(Journal article, 2021)VO2 nanoparticle–based thermochromic films have shown great promise for applications in smart windows because of their relatively high luminous transmittance and solar modulation ability. To improve the lifetime of VO2 ... -
Influence of Soil Parameters on the Fatigue Lifetime of Offshore Wind Turbines with Monopile Support Structure
(Journal article; Peer reviewed, 2016)Designing support structures for offshore wind turbines is a complex task as these are highly dynamic systems subjected to long-term cyclic loads with variable amplitude. Long-term cyclic loading may cause stiffening or ... -
Influence of structural design on building costs
(Master thesis, 2016)This paper deals with the analysis and design of two buildings for two different uses. The first one is intended for residential use, while the second is designed for office usage. These buildings will be located in the ... -
Influence of subjectivity in geological mapping on the net penetration rate prediction for a hard rock TBM
(Journal article; Peer reviewed, 2018)The net penetration rate of hard rock tunnel boring machines (TBM) is influenced by rock mass degree of fracturing. This influence is taken into account in the NTNU prediction model by the rock mass fracturing factor (ks). ... -
Influence of Subsoil Conditionson the Design and Performance of Flexible Pavements
(Doktoravhandlinger ved NTNU, 1503-8181; 2014:269, Doctoral thesis, 2014)The effect of subsoil conditions is one of the prominent factors that control both the design and performance of flexible pavement structures. Despite having a wide range of empirical methods from measurements and experience, ... -
Influence of the upstream cylinder and wave breaking point on the breaking wave forces on the downstream cylinder
(Chapter, 2017)The interaction of breaking waves with marine structures involves complex free surface deformation and instantaneous loading on the structural members. A typical offshore platform or a coastal structure consists of several ... -
Informasjonsflyt i en BIM-basert byggeprosess
(Master thesis, 2009) -
Informasjonsflyt mellom prosjektering og produksjon - Prosjekteringsledelse i totalentreprise
(Master thesis, 2018)Prosjekteringsprosessen i byggeprosjekter kan være utfordrende og kompleks. Flere aktører er involvert og det inkluderes store mengder informasjon. For en vellykket gjennomføring av byggeprosjekter er evnen til å samarbeide ... -
Informasjonsflyt på byggeplassen - Med fokus på digitale kommunikasjonskanaler
(Master thesis, 2018)En av hovedårsakene til forsinkelser og kostnadsoverskridelser i byggeprosjekter er ineffektiv informasjonsflyt. Spesielt under produksjonsfasen må store mengder informasjon koordineres mellom mange aktører. God administrering ...