Browsing Publikasjoner fra CRIStin - NTNU by Title
Now showing items 21756-21775 of 37304
-
Modeling a Supply Chain for Carbon Capture and Offshore Storage - A German-Norwegian Case Study
(Peer reviewed; Journal article, 2023)Carbon capture and storage (CCS) for industrial emission point sources is one of the potential instruments to achieve net-zero carbon dioxide () goals. However, emission point sources and storage formations are often far ... -
Modeling Adaptive Security in IoT Driven eHealth
(Chapter, 2013) -
Modeling Alumina Feeding With the µ(I)-Rheology
(Journal article; Peer reviewed, 2023)Efficient feeding and dissolution of alumina are necessary in order to maintain a stable Hall–Héroult process. One dose of alumina contains several thousand grains, and simulating the motion of individual particles is in ... -
Modeling and analysis of grid-synchronizing stability of a Type-IV wind turbine under grid faults
(Peer reviewed; Journal article, 2020)Transient behavior and response of wind turbines have been extensively studied in the context of the low-voltage-ride-through (LVRT) for many years, in which the identified transients are mostly associated with circuit ... -
Modeling and Analysis of Motion Data from Dynamically Positioned Vessels for Sea State Estimation
(Chapter, 2019)Developing a reliable model to identify the sea state is significant for the autonomous ship. This paper introduces a novel deep neural network model (SeaStateNet) to estimate the sea state based on the ship motion data ... -
Modeling and analysis of performance and emissions of marine lean-burn natural gas engine propulsion in waves
(Peer reviewed; Journal article, 2020)In many vessels, the prime mover is a diesel engine, while the researchers recommended using natural gas as an attractive option to comply with the latest emission legislations. This study aims to analyze the dynamic ... -
Modeling and Analysis of SOGI-PLL/FLL-based Synchronization Units: Stability Impacts of Different Frequency-feedback Paths
(Peer reviewed; Journal article, 2020)— Second-order Generalized Integrator (SOGI)-based quadrature-signal-generator (QSG) together with either a phaselocked-loop (PLL) or a frequency-locked-loop (FLL) constitute two types of typical synchronization units ... -
Modeling and Control for Dynamic Positioned Marine Vessels in Drifting Managed Sea Ice
(Journal article; Peer reviewed, 2014)This paper presents a development framework for dynamic positioning control systems for marine vessels in managed ice. Due to the complexity of the vessel-ice and ice-ice interactions a configurable high fidelity numerical ... -
Modeling and Control of a Bifilar Crane Payload
(Journal article; Peer reviewed, 2018)This paper presents a modeling technique and a controller for an underactuated crane payload. The crane payload is modeled as a bifilar pendulum. The payload is attached to a sheave block, such that a cable can freely run ... -
Modeling and Control of a Marine Diesel Engine driving a Synchronous machine and a Propeller
(Journal article; Peer reviewed, 2014)In some designs of power systems for marine vessels, large-size or medium-size Diesel engine(s) is(are) used to drive one synchronous machine to generate electricity, and the main propeller, simultaneously, through a gear ... -
Modeling and control of an inline deoiling hydrocyclone *
(Journal article; Peer reviewed, 2018)In subsea oil and gas production and processing, automatic control of operation is of significant importance. Typically, processing in subsea fields involves separation of hydrocarbons from water and rejection of water in ... -
Modeling and Control of Crane Overload Protection During Marine Lifting Operation Based on Model Predictive Control
(Chapter; Peer reviewed, 2017)This paper deals with a nonlinear model predictive control (NMPC) scheme for a winch servo motor to overcome the sudden peak tension in the lifting wire caused by a lumped-mass payload at the beginning of a lifting off or ... -
Modeling and Control of Heave-Induced Pressure Fluctuations in Managed Pressure Drilling
(Journal article; Peer reviewed, 2013)Automatic managed pressure drilling is an advanced pressure-control method which is intended to meet the increasingly high demands in drilling operations in the oil and gas industry. In this method, the circulating drilling ... -
Modeling and control of ship propulsion with shaft generator and battery storage system
(Chapter, 2022)The use of shaft generators in marine applications makes it possible to operate the main engine more efficiently and to provide additional power to the electrical system. This paper develops a dynamic model and controller ... -
Modeling and Delay Analysis for SDN-based 5G Edge Clouds
(Peer reviewed; Journal article, 2020)The fifth generation (5G) mobile networks are envisioned to provide connectivity not only to mobile users but also to a wide range of other services such as enhanced mobile broadband (eMBB) and massive Internet of Things ... -
Modeling and Evaluating NFV-Enabled Network Services under Different Availability Modes
(Chapter, 2019)Network and Telecom operators are continuously embracing the adoption of Network Function Virtualization (NFV) as a means to provide more agile, flexible and cost-efficient services. Many telecommunication services need ... -
Modeling and Executing Cyber Security Exercise Scenarios in Cyber Ranges
(Peer reviewed; Journal article, 2022)The skill shortage in global cybersecurity is a well-known problem; to overcome this issue, cyber ranges have been developed. These ranges provide a platform for conducting cybersecurity exercises; however, conducting such ... -
Modeling and nonlinear model predictive control of a subsea pump station
(Journal article; Peer reviewed, 2017)In this paper we present a model of a pump station consisting of two pumps in parallel with a recycle line, and a nonlinear Model Predictive Control strategy for said pump station with suction pressure as the controlled ... -
Modeling and Optimization of Simultaneous Waste Heat Utilization and Wastewater Treatment Processes
(Chapter, 2019)Huge amounts of low-temperature waste heat, which can be utilized to improve the energy efficiency in various ways, are available in the process industries. Organic Rankine Cycle (ORC) is one of the promising technologies ... -
Modeling and Path-following for a snake robot with active wheels
(Chapter; Peer reviewed, 2009)Snake robots with active wheels provide interesting opportunities within many areas such as inspection and maintenance and search and rescue operations. The highly-articulated body of a snake robot combined with the ...