Simulation Validation of Extruded Aluminium Quenching
Master thesis
Permanent lenke
https://hdl.handle.net/11250/3087813Utgivelsesdato
2023Metadata
Vis full innførselSamlinger
Sammendrag
Denne masteroppgaven ser på å validere simuleringene gjort i programvaren QFormsom er laget for å simulere forming av varmt metall, og spesielt ekstruderingog kjøle simuleringer. Denne valideringen vil bli gjort ved å gjenskape testersom Benteler har gjort i QFrom og sammenligne resultatene mellom testene ogsimuleringene. Testene ble gjort med 6005 som ekstruderings materiale og H13verktøy stål for former.For ekstruderingsdelen, dataen som blir sammenlignet vil være av kraften i pressenog temperaturen på metallet når det er kommet ut av formen. Forvrengningene iprofilen kan dessverre ikke sammenlignes på grunn av mangel på data.Og for kjøle simuleringene blir det å sammenligne temperatur grafene for mangeforskjellige tester, også her mangler det data på forvrengning. This thesis looks at validating the simulation software QForm made for simulatingthe processing of hot metals and, more specifically, looking at the extrusion andquenching part of the software. This will be done by recreating a test done by thecompany Benteler in software as closely as possible and comparing the results tothe data gathered from the tests. The aluminium profile used in these tests andsimulations is made in alloy 6005, and the dies are made from H13 tool steel.For the extrusion part, the comparison data relies mainly on the force and temperaturedata, as there was no distortion or other reliable data available to conclude from,though they are the most telling data to go off of.As for the quenching simulations, there is only the temperature data available,but this is the most important data type, and it is a rather large data set, so thereare data to go off of.