Analysis and Design of Ship Collision Barriers on a Submerged Floating Tunnel subjected to Large Ship Collisions
Master thesis
Date
2015Metadata
Show full item recordCollections
- Institutt for marin teknikk [3469]
Abstract
The Norwegian Public Roads Administration (NPRA) is running the project "Ferry free coastalroute E39". One of the main challenging are regarding how to cross the wide and deep fjord onthe west coast of Norway. One of the bridge design considered is a combination of a floatingbridge and a submerged floating tunnel. The transition zone between those structural partsis in special critical with respect to damage. This thesis focus at a ship collision barrier forprotection of the transition zone.
An impact with the ship collision barrier are taken as an accidental action. The design ship ishence taken as the ship which have probability of occurrence less or equal to 1x10E-4. Thiscorrespond to a cruise ship with design parameter; displacement 31 456 metric ton and impactvelocity 17.7 knots. The added mass coefficient was provided to be 0.2 and hence the totalkinetic energy for the design ship was determined to be 1565MJ. This is an severe amount ofenergy which needs to be dissipated as strain energy in the ship and then barrier. Some energywill also be dissipated by the inertia and drag forces, due to translation of the barrier.
A simplified analysis of a stiffened plate was performed by use of the nonlinear finite elementprogram LS-DYNA. The results of the analysis shows that the strength of the stiffeners werein particular relevant for small displacements. While for larger displacement the plate carriesthe load by membrane forces.
The ship collision barrier needs to be designed for dissipation of large amount of strain energy.Therefore it was decided to built the structure like an ordinary ship like structure. This meansthat the barrier consist of decks, vertical and transverse bulkheads which all are stiffened bystiffeners. In this thesis the barrier is assumed to have a straight configuration with length380m, breadth 20m, height 12m and a draft equal to 8m. The barrier is assumed to be afreely floating structure only supported by buoyancy, inertia and drag forces. The barrier weredecided to be built of aluminium alloys. Alloy 5083-O is considered for the plates and alloy6082-T6 is considered for the stiffeners.
The intact stability of the barrier was verified to be good. Since the barrier is a floating structureit had to be ballasted down to the desired design draft. The aluminium cross section isa relative light cross section. When the draft of the barrier was assumed to be 8m, the waterlevel of ballast water inside the cross section was determined to be about 7.7m.
By summarize the energy dissipated as strain energy in the ship and the barrier determinedby a strength design and a ductility design analysis, it was shown for the considered barriercross section that only about 1100MJ was dissipated. Therefore in order to dissipated thetotal amount of kinetic energy as strain energy a stronger cross section should be considered.If the analysis had accounted for energy lost due to translation of the barrier, the barrier crosssection may have been strong enough. However, integrated shared energy analyses to verifythis statement have not been completed.