• norsk
    • English
  • norsk 
    • norsk
    • English
  • Logg inn
Vis innførsel 
  •   Hjem
  • Øvrige samlinger
  • Publikasjoner fra CRIStin - NTNU
  • Vis innførsel
  •   Hjem
  • Øvrige samlinger
  • Publikasjoner fra CRIStin - NTNU
  • Vis innførsel
JavaScript is disabled for your browser. Some features of this site may not work without it.

An 11.0 bit ENOB, 9.8 fJ/conv.-step noise-shaping SAR ADC calibrated by least squares estimation

Garvik, Harald; Wulff, Carsten; Ytterdal, Trond
Journal article, Peer reviewed
Accepted version
Thumbnail
Åpne
PID4567421.pdf (3.972Mb)
Permanent lenke
http://hdl.handle.net/11250/2480319
Utgivelsesdato
2017
Metadata
Vis full innførsel
Samlinger
  • Institutt for elektroniske systemer [1555]
  • Publikasjoner fra CRIStin - NTNU [20842]
Originalversjon
10.1109/CICC.2017.7993659
Sammendrag
A noise-shaping SAR ADC implemented in 28 nm UTBB FDSOI is presented. A cascaded FIR-IIR loop filter topology is used, and implemented as an inverter-based switched-capacitor circuit. The loop filter also employs input buffers. To correct CDAC mismatch, an off-line calibration technique that estimates the CDAC calibration coefficients from a digitized test sequence is proposed and used. At 28 MS/s and Nyquist bandwidth of 1.75 MHz, the measured accuracy is 11.0 bit ENOB, and the Walden FOM 9.8 fJ/conv.-step.
Utgiver
Institute of Electrical and Electronics Engineers (IEEE)
Tidsskrift
Proceedings of the IEEE Custom Integrated Circuits Conference

Kontakt oss | Gi tilbakemelding

Personvernerklæring
DSpace software copyright © 2002-2019  DuraSpace

Levert av  Unit
 

 

Bla i

Hele arkivetDelarkiv og samlingerUtgivelsesdatoForfattereTitlerEmneordDokumenttyperTidsskrifterDenne samlingenUtgivelsesdatoForfattereTitlerEmneordDokumenttyperTidsskrifter

Min side

Logg inn

Statistikk

Besøksstatistikk

Kontakt oss | Gi tilbakemelding

Personvernerklæring
DSpace software copyright © 2002-2019  DuraSpace

Levert av  Unit