| dc.description.abstract | When considering cable-supported bridges, forces from wind and earthquakes often governs
design. Heavy vehicles can also excite considerable vibrations on long and slender bridges,
and may excite other frequencies in the bridge than the wind. If those frequencies are close
to the resonance frequencies of the bridge, this response will be critical. As such, it is of
interest to accumulate knowledge considering characteristics of traffic induced vibrations on
slender bridges.
In this thesis, methods for examining the traffic induced response on cable-supported bridges
have been proposed. In order to identify traffic on bridges, and the response invoked by said
traffic, numerical methods of analysing recorded data from existing bridge structures have
been derived and reviewed, and a finite element analysis for simulating the effect of traffic
loading on bridges has been established and investigated. A case study on the Hardanger
Bridge was carried out as a means of verifying the methods. Recordings from accelerometers
along the bridge was used in the analysis, and a traffic logging at the site provided information regarding the actual traffic situation at the bridge for a time series.
It was found that heavy vehicles can be identified from the vertical acceleration response,
as the frequency of the oscillations in the acceleration response increases significantly. The presence of passenger cars on the bridge does not seem to affect the acceleration response noticeably. The use of cross-covariance as a means of identifying moving loads and their characteristics, proved unsuccessful. Other factors than traffic seems to contribute to the acceleration response, and as such the cross-covariance did not provide satisfactory results due to the complexity of the response.
The power spectra of the recorded data revealed that heavy traffic excites eigenfrequencies mostly below one hertz, but also some higher eigenfrequencies. The attempts of filtering
away wind induced response, which is in general present below one hertz in the frequency
spectra, proved unsuccessful as most of the traffic induced response happens in the same frequency spectra as the wind. Because of this, the wind-traffic interaction on bridges appear to be significant, and should be considered in analyses.
Integration of the recorded accelerations was shown to give good results as a means of
obtaining displacements, with the exception of a non-existing eigenfrequency appearing and
getting excited with a high amplitude, providing some uncertainty regarding the results. As
such further study on the subject is recommended.
The findings suggests that a finite element moving load model, consisting of a moving force
representing each axle of the vehicle, may be used to conservatively estimate the response
of a bridge. The recorded data gives a smaller response than the Abaqus model, but the car
loggings used for the recorded data were done during times of high wind velocities, which
is assumed to provide a stiffer response of the bridge. Further study on the wind-traffic
interaction, is recommended. | |
