PARAMETRIC OPTIMISATION OF FRICTION STIR WELDING ON ALUMINIUM ALLOY (EN AW-1100) PLATES
Awan, Muhammad Umer Farooq; Khan, Mahmud Tareq Hassan; Waheed, Khalid; Iqbal, Zafar; Rehman, Abdul; Ali, Fahad; Shahzad, Muhammad; Saim, Muhammad Abdul Basit; Akhtar, Shahid; Aune, Ragnhild Elizabeth
Peer reviewed, Journal article
Published version
View/ Open
Date
2023Metadata
Show full item recordCollections
- Institutt for materialteknologi [2565]
- Publikasjoner fra CRIStin - NTNU [38655]
Abstract
Friction stir welding is a solid-state welding process used extensively for aluminium alloys. EN AW-1100 alloy is mostly used for its exceptional corrosion resistance, high ductility, high thermal and electrical conductivities, and cost-effectiveness. This study is focused on the optimisation of friction stir welding parameters to achieve enhanced mechanical properties of 5mm thick EN AW-1100 alloy plates welded with a single pass, using Taguchi L9 orthogonal array and ANOVA analysis. Experimental results revealed that maximum tensile strength of 79 MPa and percentage elongation of 38.87 % were achieved. The maximum Vickers hardness achieved in the stir zone was 34.15. These results were used for optimisation using Minitab and it was determined that 2000 RPM, 30 mm·min−1 traverse speed and square probe profile came out to be the best parameters for maximum tensile strength. 4000 RPM, 30 mm·min−1 traverse speed and square probe geometry were the best parameters for maximum hardness in the stir zone. ANOVA analysis showed that the most significant parameter for tensile strength was traverse speed. None of the considered parameters were influencing the hardness value in the stir zone at a 95 % confidence level.