Sintering of sub-micron K0.5Na0.5NbO3 powders fabricated by spray pyrolysis
Journal article, Peer reviewed
MetadataVis full innførsel
OriginalversjonJournal of the European Ceramic Society. 2015, 35 (5), 1449-1457. 10.1016/j.jeurceramsoc.2014.11.011
K0.5Na0.5NbO3 (KNN)-based ceramics are promising lead-free piezoelectrics, but processing of these materials is an ongoing challenge. Here, we present a spray pyrolysis route to highquality KNN-based powders. Fine-grained (<100 nm as-prepared, ~130 nm calcined at 800 °C) and phase-pure KNN and Li0.03K0.485Na0.485Nb0.8Ta0.2O3 (KNNLT) powders were obtained from aqueous precursor solutions. Ceramics with 95 % of theoretical density and with normalized strain of 333 pm/V were obtained by conventional sintering. The sintering of KNN remained challenging even for the fine grained powders, and the origins of these processing challenges were investigated by dilatometry and electron microscopy. Coarsening into cuboidal grains, which strongly reduced the sinterability, was observed in alkali-oxide excess KNN, caused by the formation of a liquid phase at ~650 °C. We propose that the reactivity of alkali oxide with moisture and carbon dioxide at lower temperatures cause the formation of the liquid phase at the surface even for stoichiometric KNN powders. Evaporation, mainly of potassium oxide, at high temperatures was shown to cause the formation of a Nb-rich secondary phase. The segregation of a secondary phase and inhomogeneous distribution of K/Na are discussed in relation to sintering above the solidus temperature of KNN.