Vis enkel innførsel

dc.contributor.authorLeerbeck, Kenneth
dc.contributor.authorBacher, Peder
dc.contributor.authorJunker, Rune Grønborg
dc.contributor.authorTveit, Anna
dc.contributor.authorCorradi, Olivier
dc.contributor.authorMadsen, Henrik
dc.contributor.authorEbrahimy, Razgar
dc.date.accessioned2022-09-16T13:46:50Z
dc.date.available2022-09-16T13:46:50Z
dc.date.created2021-03-04T20:01:19Z
dc.date.issued2020
dc.identifier.citationEnergies. 2020, 13 (11), 1-19.en_US
dc.identifier.issn1996-1073
dc.identifier.urihttps://hdl.handle.net/11250/3018522
dc.description.abstractAn optimized heat pump control for building heating was developed for minimizing CO 2 emissions from related electrical power generation. The control is using weather and CO 2 emission forecasts as inputs to a Model Predictive Control (MPC)—a multivariate control algorithm using a dynamic process model, constraints and a cost function to be minimized. In a simulation study, the control was applied using weather and power grid conditions during a full-year period in 2017–2018 for the power bidding zone DK2 (East, Denmark). Two scenarios were studied; one with a family house and one with an office building. The buildings were dimensioned based on standards and building codes/regulations. The main results are measured as the CO 2 emission savings relative to a classical thermostatic control. Note that this only measures the gain achieved using the MPC control, that is, the energy flexibility, not the absolute savings. The results show that around 16% of savings could have been achieved during the period in well-insulated new buildings with floor heating. Further, a sensitivity analysis was carried out to evaluate the effect of various building properties, for example, level of insulation and thermal capacity. Danish building codes from 1977 and forward were used as benchmarks for insulation levels. It was shown that both insulation and thermal mass influence the achievable flexibility savings, especially for floor heating. Buildings that comply with building codes later than 1979 could provide flexibility emission savings of around 10%, while buildings that comply with earlier codes provided savings in the range of 0–5% depending on the heating system and thermal mass.en_US
dc.language.isoengen_US
dc.publisherMDPIen_US
dc.rightsNavngivelse 4.0 Internasjonal*
dc.rights.urihttp://creativecommons.org/licenses/by/4.0/deed.no*
dc.titleControl of Heat Pumps with CO2 Emission Intensity Forecastsen_US
dc.title.alternativeControl of Heat Pumps with CO2 Emission Intensity Forecastsen_US
dc.typePeer revieweden_US
dc.typeJournal articleen_US
dc.description.versionpublishedVersionen_US
dc.source.pagenumber1-19en_US
dc.source.volume13en_US
dc.source.journalEnergiesen_US
dc.source.issue11en_US
dc.identifier.doi10.3390/en13112851
dc.identifier.cristin1895746
cristin.ispublishedtrue
cristin.fulltextoriginal
cristin.qualitycode1


Tilhørende fil(er)

Thumbnail

Denne innførselen finnes i følgende samling(er)

Vis enkel innførsel

Navngivelse 4.0 Internasjonal
Med mindre annet er angitt, så er denne innførselen lisensiert som Navngivelse 4.0 Internasjonal