Vis enkel innførsel

dc.contributor.advisorNielsen, Torbjørn K.
dc.contributor.advisorDahlhaug, Ole Gunnar
dc.contributor.advisorStorli, Pål-Tore Selbo
dc.contributor.authorSvarstad, Magni Fjørtoft
dc.date.accessioned2019-04-08T12:41:21Z
dc.date.available2019-04-08T12:41:21Z
dc.date.issued2019
dc.identifier.isbn978-82-326-3703-4
dc.identifier.issn1503-8181
dc.identifier.urihttp://hdl.handle.net/11250/2593736
dc.description.abstractThe future demands of energy production to balance more intermittent energy sources creates two main technical challenges for the hydro power production. Increased off-design operation, including both operation outside Best Efficiency Point and more starts and stops, are needed to facilitate use of more intermittent energy resources. In addition to this there is a demand for rapid change between storing and generating energy in pump storage power plants. There is therefore a need to improve the fundamental understanding of transient operation of the reversible pump turbine during different modes of operation. The present work investigates the four quadrant characteristics of a reversible pumpturbine. With focus on the fast transition between pump and turbine mode of operation. The research has consisted of both experimental work and transient simulation. A fast transition is described in this thesis as a method to change from pump to turbine mode of operation, using the head to change the direction of the pumpturbines rotational speed from pump to turbine direction. The procedure start in normal pump mode of operation and end at idle speed in turbine mode of operation, and the guide vanes are open during the whole transition. The most important contributions in this thesis is connected to the fast transition, where the field experiments is a proof of concept for the fast transition method. The pressure pulsations during the fast transition are also compared to a normal procedure of change from pump to turbine mode of operation. The fast transition is also simulated using a 1D numerical model capable of simulating both pump and turbine mode of operation. The laboratory characteristics have been important in comparison to the improved 1D simulation model. The numerical and measured results show a good correlation.nb_NO
dc.language.isoengnb_NO
dc.publisherNTNUnb_NO
dc.relation.ispartofseriesDoctoral theses at NTNU;2019:49
dc.relation.haspartPaper 1: Svarstad, Magni Fjørtoft; Nielsen, Torbjørn Kristian. Fast transition from pump to turbine mode of operation. International Journal of Fluid Machinery and Systems 2018 ;Volum 11.(3) s. 304-311nb_NO
dc.relation.haspartPaper 2: Svarstad, M. F., Nielsen, T. K. Pressure pulsations during a fast transition from pump to turbine mode of operation in laboratory and field experiment. IOP Conference Series: Earth and Environmental Science, Volume 240, 8 Energy Storage System by Hydropower Plants. Content from this work may be used under the terms of the Creative Commons Attribution 3.0 licence. (CC BY 3.0) https://doi.org/0.1088/1755-1315/240/8/082006nb_NO
dc.relation.haspartPaper 3: Svarstad, M. F., Nielsen, T. K. A comparison of pressure pulsations during normal and fast transition from pump to turbine mode of operation - This paper is awaiting publication and is not included in NTNU Opennb_NO
dc.relation.haspartPaper 4: Svarstad, M. F., Nielsen, T. K., Storli P. T. Four quadrant characteristics simulated with 1D RPT model - This paper is awaiting publication and is not included in NTNU Opennb_NO
dc.titleFast Transition between Operational Modes of a reversible Pump-Turbinenb_NO
dc.typeDoctoral thesisnb_NO
dc.subject.nsiVDP::Technology: 500::Environmental engineering: 610nb_NO


Tilhørende fil(er)

Thumbnail
Thumbnail

Denne innførselen finnes i følgende samling(er)

Vis enkel innførsel