Vis enkel innførsel

dc.contributor.authorHeydari‐Meybodi, Mahdi
dc.contributor.authorAyatollahi, Majid R.
dc.contributor.authorDehghany, Mohammad
dc.contributor.authorBerto, Filippo
dc.date.accessioned2019-02-26T10:01:42Z
dc.date.available2019-02-26T10:01:42Z
dc.date.created2018-11-26T13:29:13Z
dc.date.issued2018
dc.identifier.citationFatigue & Fracture of Engineering Materials & Structures. 2018, .nb_NO
dc.identifier.issn8756-758X
dc.identifier.urihttp://hdl.handle.net/11250/2587409
dc.description.abstractIn this study, the rupture load in rubbers weakened by sharp V‐notch is investigated under mode I loading. To this end, first, mode I fracture tests are performed on V‐notched samples made of styrene‐butadiene rubbers and the corresponding rupture loads are obtained. Then, the effective stretch (ES) criterion, which was recently developed by the present authors for rupture assessment of cracked rubber parts, is extended and used for the V‐notched rubbers. It is shown that similar to cracked rubbers, the state of stress near the notch tip is also nearly uniaxial. By employing the ES criterion, the critical displacements corresponding to the rupture in the tested samples are calculated. Finally, the predictions of the criterion are compared with the corresponding experimental values, and good consistency is shown to exist.nb_NO
dc.language.isoengnb_NO
dc.publisherWileynb_NO
dc.titleFracture analysis of V‐notched rubbers: An experimental and theoretical studynb_NO
dc.typeJournal articlenb_NO
dc.description.versionsubmittedVersionnb_NO
dc.source.pagenumber11nb_NO
dc.source.journalFatigue & Fracture of Engineering Materials & Structuresnb_NO
dc.identifier.doi10.1111/ffe.12947
dc.identifier.cristin1635114
dc.description.localcodeThis is the pre-peer reviewed version of an article, which has been published in final form at [https://doi.org/10.1111/ffe.12947]. This article may be used for non-commercial purposes in accordance with Wiley Terms and Conditions for Self-Archiving.nb_NO
cristin.unitcode194,64,92,0
cristin.unitnameInstitutt for maskinteknikk og produksjon
cristin.ispublishedtrue
cristin.fulltextpostprint
cristin.fulltextoriginal
cristin.qualitycode2


Tilhørende fil(er)

Thumbnail

Denne innførselen finnes i følgende samling(er)

Vis enkel innførsel