Vis enkel innførsel

dc.contributor.advisorRönnquist, Anders
dc.contributor.authorHaugland, Fredrik Hugo
dc.date.accessioned2015-10-05T15:17:42Z
dc.date.available2015-10-05T15:17:42Z
dc.date.created2015-06-09
dc.date.issued2015
dc.identifierntnudaim:13315
dc.identifier.urihttp://hdl.handle.net/11250/2351443
dc.description.abstractThe behavior of railway systems, in particular the overhead contact line (OCL), is considered in this thesis. The modelling of such systems with the use of the finite element method are important to carry out, both to determine the systems static and dynamic behavior. The dynamic behavior is primarily related to the relationship between the overhead contact line and the pantograph, which should ensure stable currents to the train. The aim for this study was to make a numerical model of a simplified, laboratory version of an OCL. The laboratory model consisted of two spans approximately 15m long, with a support in the middle. The finite element modelling was carried out both by the use of Python scripting, and by the use of Abaqus/CAE version 6.14 as numerical software. Laboratory measurements were conducted, primarily to validate the numerical model, but also to compare the behavior of the laboratory model in relation to existing OCLs. The results of the measurements indicated that the laboratory model was approximately 3-4 stiffer in the vertical direction, compared to existing OCLs. The numerical model was compared with the measurements conducted in the laboratory, which comparison primarily was related to natural frequencies and the variation of elasticity along the span. Comparison between the results obtained in the laboratory and the numerical results showed the same trend both due to natural frequency and elasticity, but the numerical model was created both less stiff and more dense than the laboratory model. Despite the latter, the numerical model was regarded as plausible in comparison to the laboratory model, and it was further used in two parameter studies. The parameter studies performed were related to: 1. The development of the first vertical natural frequency, for varied tension in the contact andmessenger wire. 2. The effect of removing droppers from the system, in relation to the first and the second vertical natural frequency. The results obtained in these parameter studies showed first of all that the development of the first natural frequency was dependent on whether it was the contact or messenger wire that was applied the highest magnitude of tension. Further, the removal of a dropper in the model seemed to have more effect on the first natural frequency, than the second natural frequency. In future work, it is recommended that natural frequencies of higher modes than the first and the second are investigated. The development of the first natural frequency of existing OCLs should be compared with the results obtained in the parameter study made in this thesis, to further validate the conclusions made.
dc.languageeng
dc.publisherNTNU
dc.subjectBygg- og miljøteknikk, Beregningsmekanikk
dc.titleDynamic Behavior of a Full Scale Laboratory Model of a Catenary System by Measurements and Numerical Analysis
dc.typeMaster thesis
dc.source.pagenumber197


Tilhørende fil(er)

Thumbnail
Thumbnail
Thumbnail

Denne innførselen finnes i følgende samling(er)

Vis enkel innførsel