Now showing items 1898-1917 of 2573

    • Quality Assessment of Raw Water and Impact on Pool Water Condition 

      Syversrud, Even Østby (Bachelor thesis, 2024)
      Denne oppgaven har som mål å undersøke effekten av drikkevann og sjøvann som inntaksfaktorer i ulike basseng på Pirbadet, samt deres innvirkning på målbare organiske forbindelser. Studien bygger på funn fra en tidligere ...
    • Quality of Cancer Care in Tanzania as Experienced by Patients: A Qualitative Study 

      Kidayi, Paulo L.; Manhica, Hélio; Mtuya, Christina C.; Mahande, Michael Johnson; Furaha, Serventi; Aune, Ragnhild Elizabeth; Björling, Gunilla (Peer reviewed; Journal article, 2023)
      Introduction Cancer is a disease of public importance in Tanzania. Considering a limited health care system with few cancer centers and low health literacy in general, people are diagnosed at late stage and face difficulties ...
    • Quality Of Life in Children With Home Mechanical Ventilation – A Scoping Review 

      Mattson, Janet; Lunnelie, Johan; Löfholm, Tim; Andersson, Elina Scheers; Aune, Ragnhild Elizabeth; Björling, Gunilla (Peer reviewed; Journal article, 2022)
      Introduction Home mechanical ventilation is an established method to support children suffering from chronic respiratory insufficiency, still more research is needed regarding mechanically ventilated children's and ...
    • Quantifying the grain boundary segregation strengthening induced by post-ECAP aging in an Al-5Cu alloy 

      Jia, Hailong; Bjørge, Ruben; Cao, Lingfei; Hui, Song; Marthinsen, Knut; Li, Yanjun (Journal article, 2018)
      Hardening on annealing (HOA) has been frequently observed in nanostructured metals and alloys. For nanostructured materials obtained by severe plastic deformation (SPD), HOA has been attributed to the reduction of dislocation ...
    • A Quantitative Investigation of Functionalized Glazing Stacks by Atom Probe Tomography 

      Perrin Toinin, Jacques; Hatzoglou, Constantinos; Voronkoff, Justine; Montigaud, Hervé; Guimard, Denis; Wuttig, Matthias; Vurpillot, François; Cojocaru-Mirédin, Oana (Peer reviewed; Journal article, 2022)
      Insulating glazings used in products for the building and automotive market consist of flat glass with low-emissivity (low-E) coatings. One challenge is to increase the infrared reflectance of the glazing stack while ...
    • Quantitative mapping of nanotwin variants in the bulk 

      Schultheiss, Jan; Porz, Lukas; Kodumudi Venkataraman, Lalitha; Höfling, Marion; Yildirim, Can; Cook, Phil; Detlefs, Carsten; Gorfman, Semën; Rödel, Jürgen; Simons, Hugh (Peer reviewed; Journal article, 2021)
      Crystallographic twins are critical to the properties of numerous materials from magnesium alloys to piezoelectrics. Since the onset of the twin formation is highly sensitive to the triaxial mechanical boundary conditions, ...
    • QUANTITATIVE MINERALOGY OF HIGH PURITY QUARTZ, CASE OF SPRUCE PINE, NORTH CAROLINA 

      Manyara, Saimon Gerald (Master thesis, 2014)
      High Purity Quartz is one of the important minerals in the electronic industry today, but production of extreme high purity quartz requires a detailed knowledge of the resource from mine to the processing plant. To achieve ...
    • Quantitative study of grain refinement in Al-Mg alloy processed by equal channel angular pressing at cryogenic temperature 

      Chen, Yongjun; Roven, Hans Jørgen; Subbarayan, Sapthagireesh; Skaret, Pål Christian; Hjelen, Jarle (Journal article; Peer reviewed, 2011)
      Strain induced grain refinement of an Al–1 wt.% Mg alloy processed by equal channel angular pressing (ECAP) at cryogenic temperature is investigated quantitatively. The results show that both mean grain and subgrain sizes ...
    • Quartz Behavior in Si Production 

      Zhang, Xinhao (Master thesis, 2013)
      The results of this study show the main findings in this work. The points are summarized as follow:1.With the temperature increased, many cracks formed inside the quartz. When the temperature was approaching melting point, ...
    • Raman spectroscopy of mackinawite FeS in anodic iron sulfide corrosion products 

      Genchev, Georgi; Erbe, Andreas (Journal article; Peer reviewed, 2016)
      Raman spectroscopy in a confocal microscope was used to study electrochemically synthesized corrosion products from sour gas experiments. When exposed to oxygen-containing atmosphere, the initial mackinawite FeS corrosion ...
    • A Raman-Structure Model for the Viscosity of SiO2- CaO-Al2O3 System 

      Haghdani, Shokouh; Tangstad, Merete; Einarsrud, Kristian Etienne (Peer reviewed; Journal article, 2022)
      The relationship between structure and viscosity of molten slags is investigated using the Raman spectroscopy technique. To this end, a group of 20 synthetic slags in the SiO2-CaO-Al2O3 ternary system is considered. The ...
    • Raney-platinum thin film electrodes for the catalysis of glucose in abiotically catalyzed micro-glucose fuel cells 

      Do, Uyen Phuong; Seland, Frode; Wang, Kaiying; Johannessen, Erik Andrew (Journal article; Peer reviewed, 2019)
      Fuel cells capable of synthetic glucose catalysis have revolved around the implementation of abiotic catalysts that require extreme acid and alkaline environments. These are not compatible with implantable medical sensor ...
    • Rational design of mixed solvent and porous graphene-supported spinel oxide electrodes for high-rate and long cycle-life Mg batteries 

      Wang, Lu; Shao, Yuanlong; Jiang, Bo; Fiksdahl, Anne; Jayasayee, Kaushik (Peer reviewed; Journal article, 2019)
      The development of Mg batteries based on the interfacial charge storage mechanism, where the capacity originates from capacitive processes and the solvent-related interfacial reactions, could efficiently circumvent the ...
    • Rationalization of hydrothermal synthesis of NaNbO3 by rapid in situ time-resolved synchrotron X-ray diffraction 

      Skjærvø, Susanne Linn; Wells, Kristin Høydalsvik; Sommer, Sanna; Vu, Tuong-Dan; Tolchard, Julian R; van Beek, Wouter; Grande, Tor; Iversen, Bo B.; Einarsrud, Mari-Ann (Journal article; Peer reviewed, 2018)
      In situ monitoring of the formation of crystalline phases during conventional hydrothermal synthesis is experimentally challenging. Here, we report an in situ time-resolved synchrotron X-ray diffraction study during ...
    • Rayleigh analysis of dielectric properties in textured K0.5Na0.5NbO3 ceramics 

      Haugen, Astri Bjørnetun; Morozov, Maxim; Jones, Jacob L.; Einarsrud, Mari-Ann (Journal article; Peer reviewed, 2014)
      Grain texturing is a known method of exploiting the intrinsic dielectric and piezoelectric anisotropy in ferroelectric ceramics. However, the role of crystallographic texture on anisotropic extrinsic contributions including ...
    • Reaction kinetics for reduction of manganese ore with carbon monoxide in the presence of carbon 

      Ishak, Rodney (Dr. ingeniøravhandling, 0809-103X; 2002:135, Doctoral thesis, 2002)
      In the production of ferromanganese the gas-solid reactions taking place in the furnace shaft (the so-called pre-reduction zone, where higher manganese oxides in the manganese ore are reduced to MnO) are to a large extent ...
    • Reaction pathway of the hydrothermal synthesis of AgCuO2 from in situ time-resolved X-ray diffraction 

      Liu, hongjun; Grendal, Ola Gjønnes; Skjærvø, Susanne Linn; Dalod, Antoine Robert Marie; van Beek, Wouter; sekkat, abderrahime; Einarsrud, Mari-Ann; munoz-Rojas, David (Journal article; Peer reviewed, 2020)
      AgCuO2 is an interesting semiconductor oxide with appealing optical and electronic properties. While the oxide has been synthesized in bulk by different approaches, no study on the formation mechanism has been carried out ...
    • Reaction Rate Analysis of Manganese Ore Prereduction in CO-CO2 Atmosphere 

      Larssen, Trine Asklund; Senk, Dieter Georg; Tangstad, Merete (Peer reviewed; Journal article, 2021)
      Variations in energy efficiency and climate gas emissions in production of manganese ferroalloys are largely related to the solid-state reduction of the manganese ores used as raw material in the production. The gas-solid ...
    • Reactivity assessment of charcoal for use in silicon production 

      Ramos, D.C.; Carneiro, A.C.O.; Tangstad, Merete; Pereira, B.L.C.; Saadieh, Raghed; Oliveira, A.C.; Vital, B.R. (Peer reviewed; Journal article, 2021)
      As charcoal is used in the silicon metal process, reactivity towards SiO is one of the most important properties that has strong effects on silicon recovery. The purpose of this study was to analyze anatomical properties ...
    • Reactivity of Calcined Clays 

      Danner, Tobias (Doktoravhandlinger ved NTNU, 1503-8181; 2013:218, Doctoral thesis, 2013)
      With 3-5 billion tons cement-produced every year, the cement industry is today the third largest emitter of CO2 in the world after fossil-fuel based energy plants serving heating/cooling of buildings and combustion engines ...