Simulation of flow around a Viking ship rudder.
Master thesis
Permanent lenke
http://hdl.handle.net/11250/2350812Utgivelsesdato
2015Metadata
Vis full innførselSamlinger
- Institutt for marin teknikk [3473]
Sammendrag
Computational fluid dynamics (CFD) is a numerical method of solving the Navier-Stokesequations for all points in a grid, or mesh. By performing this operation over multipletime steps, the resulting velocity and pressure field can be found. This method has beenused to simulate the flow past a Viking ship rudder at different flow regimes.
During sailing with a replica of the Oseberg ship, loss of steering power were experiencedwhen the ship turned to starboard. The reason for this was determined to be the rudder shape. A thicker and longer rudder was made, with the intention to customise the rudder by gradually removing the extra thickness. The rudder had better steering, but not as good as when it turned to port. Moreover, it vibrated at certain angles of attack.
Several CFD analysis has been performed to examine what s causing the loss of liftand vibrations experienced by the rudder. A mesh of the fluid surrounding the rudderwas generated using an in-house mesh generator developed at NTNU. The rudder wasanalysed from angles of attack α=-10 to α=10 degrees, with a 5 degree increase betweensimulations. A validation study of NACA0012 airfoil was performed as a part of theproject thesis, and mesh convergence test were performed on the Oseberg rudder mesh.The angles were tested at rudder rake angles of 20,25 and 30 degrees, at Reynolds number250, 1000 and 2.4× 10^6 . The latter corresponds to a fully developed turbulent flow, assuch the k- turbulence model was used. For the results the mean drag and lift coefficient, standard deviation and the resulting moments on the free surface was determined. The flow field was then examined through vorticity, characteristics of flow separation and pressure distribution n the surface of the rudder.
At Re=1000/Re=2.4× 106 and α=-10 there was discovered a continuous vortex sheddingon the port side of the rudder. These shed vortices gave rise to a oscillating lift force, and consequently vibrations on the rudder. It was discovered that increasing the rudder rake angle proved advantageous to avoid rapid oscillations of lift, stabilising the lift coefficient as β increased. The mean lift coefficient was higher at α=-10 than at α=10 degrees, indicating that the loss of lift is not caused by vortex shedding and flow separation.
A simplified model of ventilation were calculated to check the risk of air travelling along the rudder from the free surface due to suction pressure. At α=-10 the lowest point where ventilation can occur increase nearly linearly with β, whereas for positive α it is fairly constant. This indicates that the lift for negative angles are generated more by suction pressure than for positive angles. This could cause the lift loss under real conditions.
To avoid vibrations, the rudder need to be more streamlined. Smoothing the leadingedge will cause less flow separation, and increase stability. The rudder is slightly curved inwards at the port side. Making this side straight or with a slight outward curve will also make the rudder more stable against flow separation.